This rifle was built for me by craftsman and builder Jim Parker from Warrior, Alabama. The rifle is custom built and handcrafted by Jim to my own specifications. The barrel is a Green Mountain 50 Caliber barrel. The lock is a "Queen Anne" L & R lock. The trigger is an Early American design made by "L & R." The wood was carved from a block of Maple with a slight "curly" grain. Jim carved and did the inlay work on the stock. He purposely left the wood unsanded so as to more closely represent the original finish found on these rifles. The metal was finished to have a "rust like" look to resemble the finish on the original rifles of the period. This Southern Virginia style is typical of the rifles made by craftsman in the 1780 to 1790 period found mainly in Virginia, Tennessee and Kentucky.

The "Queen Anne" lock was a popular style lock of English origin of the late 1700s period. The maple wood with a slight "curly" grain is shown here. Note the fine hand work done by Jim Parker. No sanding was done to maintain the "original" look of rifles found during that period of rifle-making. The "double set" trigger is a L & R trigger. The L & R lock with the deep pan, large frizzen and ornate hammer are typical of English design locks of this period.

This image shows the L & R double set trigger with the Early American design of the trigger guard. The maple stock is carved by Jim Parker to duplicate the typical stock of the Southern Virginia design found on rifles of this period. The wire inlay is also typical. Jim's trade mark signature is found on the rear butt plate - three cross's inlaid into the wood.

This is the 50 yard zero target used to determine the best combination of ball size, powder load and patch size. The load determined best for a 50 yard group was a .500 Round Ball, 60 grains of fff black powder, and a .015 Teflon coated patch. The sights are perfectly set by Jim Parker as no correction was needed in either elevation or windage. The wind was calm on the day of this grouping.

These two "Post It" note squares show the result of zeroing the Southern Virginia at 50 yards after tuning up the trigger. Jim Parker, the builder did some extra work to make the trigger absolutely fine. Note that four round balls impacted through the preceding hole of the first impact! I reduced the powder load from 60 grains to 55 grains fff powder and am now using a .500 ball in lieu of the original .495 ball. Patch is now a .015 Teflon coated patch.

If you have questions about the "Southern Virginia" Flintlock you may Email me at: bill@billhaycock.net

The Master Builder of this Rifle is Jim Parker. His web site is http://www.parkerfirearms.com/main.html

HOME